NOTE • The ASPECT button does not work when no proper signal is input.
• For details, see the "Operating Guide".
• There may be some noise and/or the screen may flicker for a moment when
an operation is made. This is not a malfunction.
Turning off the power
1.
Press the STANDBY/ON button on the
projector or the remote control.
The message "Power off?" will appear on
the screen for about 5 seconds.
2.
Press the STANDBY/ON button again while
the message appears.
The light source will go off, and the POWER/
STATUS1 indicator will begin blinking in
orange. Then the POWER/STATUS1 indicator
will stop blinking and light in steady orange
when the light source cooling is completed.
WARNING
►Do not touch around the exhaust vents during use or just after
use, since it is too hot.
►Unplug the power cord for complete disconnection. The power outlet should
be close to the projector and easily accessible.
NOTE • Please power off the projector after any connected devices are
powered off.
• This projector has the AUTO POWER OFF function that can make the
projector turn off automatically. For more information, see the "Operating Guide".
POWER/STATUS1 indicator
STANDBY/ON button
INPUT
MYBUTTON
ASPECT
PbyP
AUTO
FREEZE
MAGNIFY
FOCUS
ZOOM
VOLUME
ON
OFF
PAGE
UP
GEOMETRY
PICTURE
MUTE
DOWN
INTERACTIVE
NETWORK
BLANK
ESC
MENU
ENTER
OSD MSG
RESET
15