Driveline Length Check - RHINO FR162 Operator's Manual

6.1 Driveline Length Check

Before operating the Implement, check to make sure the Implement input driveline will not
bottom out or become disengaged. Bottoming out occurs when the inner shaft penetrates
the outer housing until the assembly becomes solid-it can shorten no more. Bottoming out
can cause serious damage to the Tractor PTO by pushing the PTO into the Tractor and
through the support bearings or downward onto the PTO shaft, breaking it off. A broken
driveline can cause personal injury.
When fitting the mower to the tractor , the telescoping driveline must be inspected to ensure that at its most
compressed position, the shafts do not "bottom out", and when at its farthest extended postion, there is
sufficient engagement between the profiles to operate safely. At its shortest length, there must be at least at 1"
clearance between each profile end and opposite profile universal joint. At its farthest operating extension, a
minimum profile engagement of 6" must be maintained.
"Bottoming Out" Check Procedure
• Disconnect driveline from the tractor and slide
the profiles together until fully compressed.
• Place a mark on the inner shield 1/8" from the
end of the outer shield and reattach the
driveline to the PTO shaft.
• With the PTO NOT TURNING, slowly drive the
tractor with mower attached through the
sharpest turn possible and watch shaft
movement. With the PTO NOT TURNING,
slowly drive the tractor with the mower attached
through the most severe terrain conditions
expected and watch shaft movement.
• If the distance between the mark and the outer
shield becomes less than 2" at any point there is a potential problem bottoming out the driveline and the
driveline should be replaced with shorter driveline. Contact your local dealer or Technical Service for
Engagement Check Procedure
• With the driveline attached, position the mower to the point where the telescoping driveline is at its maximum
extension. Completely shut down the tractor and secure in position.
• Mark the inner driveline shield 1/8" from the end of the outer shield.
• Disconnect the driveline from the tractor and separate the two driveline halves.
• Measure the distance from the mark to the end of the inner profile. This length is the amount the driveline profiles were
engaged.
• If the engaged length is less than 6", the shaft is considered too short and should be replaced with a longer shaft.
Consult an authorized dealer to purchase the required driveline length.
NOTE: If the driveline cannot be shortened and still maintain the required profile engagement, the operator must be made
aware of terrain conditions and avoid situations which pose a potential problem to avoid damaging the driveline or move
drawbar to 16" or 20" position for required clearance. OPS-R-0005_O
FR240-FR162 01/11
© 2011 Alamo Group Inc.
OPERATION
(S3PT-18)
Operation Section 4-16