Assembly; Installing Mounting Brackets; Installing Loader; Installing Grease Fittings - RHINO 2412 Operator's Manual

ASSEMBLY

Assembly

Installing Mounting Brackets

Install all mounting brackets on the tractor according to instructions packed with mounting kit.

Installing Loader

Install loader onto mounting brackets on tractor according to instructions packed with mounting kit.

Installing Grease Fittings

Install 1/4 straight grease fittings (11) into the road end of bucket cylinders.
Note: Grease fittings should point upward when rod ends are attached to bucket.

Installing Bucket

Attach bucket to the lift boom frame and bucket cylinders with 1-1/4 x 8 pins (29), 1-1/2 x 8-5/8 pins (6) and
hardware (24 and 26).

Installing Bucket Level Indicator

Attach indicator guide tube (13) to the bucket cylinder base pin on the right side of lift boom frame.
Slide bucket level indicator rod (23) into the guide tube and attach the other end of rod to the bucket cylinder
rod pin.
Locate tractor and loader on level surface. With the bottom of bucket resting on surface, cut off the excess rod
(23) flush with the end of guide tube (13).
2412 01/11 Assembly Section 3-5
© 2011 Alamo Group Inc.