Table of Contents
Advertisement
Available languages
Available languages
EN
1.0
general information
2.0
2.1
2.2
burner assembly
2.3
2.4
2.5
2.6
2.7
2.8
2.9
2.10
3.0
3.1
3.2
4.0
4.1
overview
note:
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel
Ltd. reserves the right to change or modify any information within this manual at any time without
notice. Changes, other than editorial are denoted by a vertical line in the margin.
1.0 general information
This burner and log assembly are approved for use in the HD81-1 gas fireplace only. They are not approved for
use as a stand alone appliance or in conjunction with any other appliance.
2.0 installation
2.1
access panel
Once either door is removed (refer to the "door removal / installation" section of the HD81-1 manual),
A.
remove the air manifold by removing the two retaining brackets located at the top of the firebox, see Figure
1.
Remove the valve access panel and gasket by removing the 8 screws, see Firgure 2.
B.
Fig. 1
2.2
burner assembly
Attach the burner assembly to the firebox base with
A.
the screws supplied, ensure the pilot assembly is
closest to the valve access opening.
2
W415-0713 / E / 05.10.18
Fig. 2
Burner Assembly
2
2
2
2
3
3
4
4
5
6
6
6
7
7
7
8
9
Pilot
Assembly
Advertisement
Chapters
Table of Contents
