Inspecting Cords And Connectors; Replacing Cables; Replacing An Interface Cable - Honeywell Vuquest 3330 User Manual

•
•
•
•
•
•
•
•
•
•

Inspecting Cords and Connectors

Inspect the interface cable and connector for wear or other signs of damage. A
badly worn cable or damaged connector may interfere with scanner operation.
Contact your distributor for information about cable replacement. Cable replace-
ment instructions are on

Replacing Cables

The standard interface cable is attached to the scanner with an 15-pin modular
connector. The interface cable is designed to be field replaceable.
•
•

Replacing an Interface Cable

1. Turn the power to the host system OFF.
206
®
Sani-Cloth HB wipes
®
Sani-Cloth Plus wipes
®
Super Sani-Cloth wipes
Isopropyl Alcohol wipes (70%)
™
CaviWipes
®
Virex 256
®
409 Glass and Surface Cleaner
®
Windex Blue
®
Clorox Bleach – 10%
Gentle dish soap and water
Order replacement cables from Honeywell or from an authorized distributor.
When ordering a replacement cable, specify the cable part number of the
original interface cable.
b. Disconnect the scanner's cable from the
terminal or computer.
c. Rotate the two screws counter clockwise to
loosen the screws.
d. Gently pull the connector.
e. Replace with the new cable.
Insert the connector into the socket on the
3320. Rotate the two screws clockwise to
tighten.
page 206.
Vuquest 3320g User Guide