Sharedband Power Router 1 Configuration Manual

Table of Contents

Download this manual

Sharedband Bonded Broadband

Sharedband Power Router 1

Configuration Guide

This document is to instruct you how to configure the Sharedband software on Sharedband Power Router 1.

Note: This guide assumes that the Router is not pre-configured.

Make sure you have the Sharedband user details for the Community you wish to setup.

Do not skip any of the steps, as the configuration is not activated until

'Save and

reboot' is selected

at the end of the last step.

Step 1: Log onto the Web interface of the router (default address http://192.168.3.17). The default login is

'admin' and password 'Bonding123'.

Step 2: Click 'Settings' >

'Sharedband Service

Configuration'.

June 2017

http://www.sharedband.com

1 of 3

Table of Contents

Do you have a question about the Power Router 1 and is the answer not in the manual?

Page 1: Configuration Guide
Sharedband Power Router 1 Configuration Guide Introduction This document is to instruct you how to configure the Sharedband software on Sharedband Power Router 1. Note: This guide assumes that the Router is not pre-configured. Preparation Make sure you have the Sharedband user details for the Community you wish to setup.
Page 2 Step 3: You should now be presented with a screen like this: The details required for this screen are those generated when creating the user on the Sharedband NOC. The only value which differs is the 'Node ID' (1 – 8 depending on the Router number) for your WAN Ethernet connection.
Page 3 The recommendation is to increment the last digit for each Sharedband router, for example the second unit would have an address of 192.168.3.2. This is also where you can change the VRRP Address and Subnet for routed mode, this must be the same on all routers (for more information on routed mode, please contact support).