Operation - Broan 112 Instructions Manual

OPERATION

Before using heater, make sure heater has been properly installed
according to installation steps beginning with the "PLANNING"
section on page 1.
1. Turn thermostat counterclockwise to its lowest setting.
2. Turn on power to circuit at service entrance.
3. Turn thermostat clockwise. The heating element and fan should
come on. Set thermostat to desired temperature level. During
proper operation, the heater will cycle on and off periodically.
If heater does not come on:
1. Return the thermostat to lowest setting.
2. Shut off power at service entrance.
3. Remove the top cover. Check for proper line voltage and rein‑
spect wiring connections. Reread installation procedure making
sure all steps were followed.
4. Also check the thermal fuse. It may be open and need to be
replaced. Consult the service parts list for the part number of
a replacement fuse. Follow the procedure described in the last
paragraph of the warranty when ordering replacement parts.
MODEL 112
Page 3