Changing A Program; Programming The Delayed Start - Beko D 5001 E Instruction Manual

lighting continuously when the program
cancellation is completed. You may
select and operate a new program
following the program cancellation
process. There might be residues of
detergent or rinse aid left in the
machine and/or on the pieces being
washed depending on the step the
previous program was in at the time of
such cancellation.

Changing a Program

Press Start / Pause / Cancel button (7)
first to switch your machine into pause
mode if you want to change your
selection after you started the program.
Then, switch to the desired program
by pressing Program Selection
button (3). Start the new program
by pressing Start / Pause / Cancel
button (7) again. Your new selection
will resume operation from the step in
the previous program (For example,
if the previous program was in rinsing
step, the new one will also start from
the rinsing step). If you want to run
the newly selected program from the
very beginning, you have to apply the
program cancellation process first and
then select a new program.
Programming the Delayed
Start
You can delay the start of the selected
program until 24 hours. Delayed start
can not be set after the program starts.
The selected program must not be
started in order to be able to set the
delay time.
Delayed start indicator
(13) will start flashing when the
delayed start button (8) is pressed. You
can set the desired time by pressing
the delayed start button (8). Press the
Start / Pause / Cancel button (7) after
setting the time. The delayed start
indicator
lit on the display during the delayed
start countdown and the delay time
indicator (12) will display the remaining
time. Program will start automatically
when the countdown is over.
You can use the delayed start function
if you are utilizing the economic
electricity tariff.
If you want to change the program
or functions while the delayed start
function is enabled, then pause the
machine by pressing the Start / Pause
/ Cancel button (7). You will see that
the countdown stops. Select the new
program and/or add the functions
as described in Program Selection
and Table of Average Consumption
Values. Resume the delayed start
countdown by pressing the Start /
Pause / Cancel button (7).
If you want to cancel delayed start
countdown while it is in progress, then
press the Start / Pause / Cancel button
(7) for three seconds. Release the
button when
Program Indicator (19 d) start flashing
above the program indicator (11) in the
display. For a couple of minutes the
machine will fulfill the necessary
operations required for cancellation.
End of Program Indicator (19 d) starts
lighting continuously when the delayed
start countdown cancellation is
completed. You may select and
sand glass
operate a new program following the
delayed start countdown cancellation
process.
24 GB
sand glass (13) will remain
indicator and End of