Using Windows* Xp Client Configuration Manager - Intel II User Manual

Step-by-step

Using Windows* XP Client Configuration Manager

Gateway
settings
1 Refer to your Install Information Worksheet for the
wireless settings you applied to the gateway.
2 Configure the wireless adapter this way:
• Network Name (network ID code or SSID) =
same as you applied to the gateway
• Encryption = same encryption settings as
gateway
• Mode = Infrastructure
3 Verify that you can access the gateway from this PC
by inserting the gateway installation CD and clicking
the Configure the Gateway button.
If you need help doing this, refer to the adapter's
documentation.
Use the following steps to connect an 802.11b adapter
that uses the Windows XP Client Configuration Manager
to the Intel Wireless Gateway II.
If you are using Intel AnyPoint Wireless II network
adapters, and the AnyPoint Connectivity Suite software,
you must use version 2.30.01 or higher of the AnyPoint
Connectivity Suite software to be fully compatible with the
Windows XP Network Key.
If you are using a third-party adapter, follow the
instructions below. Use these instructions from the
status page on the gateway. See Viewing your
connection status on page 16 to help you find the Status
page.
Gather the following gateway settings from the Install
Information Worksheet:
• Encryption level
• Encryption password
Chapter 2 – Setting Up the Gateway on a Network
21