ASCOM U922 User Manual page 20

User Manual
Transceiver U922
2000 01 25 /Rev.A
• Whether the pocket unit should check if the radio channel is occupied or not to
ensure that the speech call will be received.
• The Sub tone frequency and the time from control tone time-out until the
pocket unit shuts off the loudspeaker and terminates the reception.
• Whether the pocket unit should receive location codes and if so, in what
interval the unit should receive the codes. Intervals is used in order to save
battery.
• Whether the pocket unit should send a strong acoustic signal after a Man
down, Push button, Pull cord, or an External alarm has been transmitted.
• Whether the pocket unit should wait for Technical acknowledgement and if so,
how and the number of times the unit is to repeat the alarm transmission.
• Whether the stored location codes should be erased when the unit is in OFF
mode.
• Whether the unit should send an alarm directly when receiving a Special
Location Transmission.
• Whether the unit should be used to test fixed locators and thereby indicate
when receiving a location code
• Whether the man down, pull cord and external alarms should be enabled. With
mandown alarm means either tilt alarm or no movement alarm. If the
mandown alarm is enabled it is also possible to set the delay and alarm duration
time of the alarm.
• The One push and two Push functions of the alarm push-button and the time
the push-button must be pressed.
TD 91836GB
20