Replacing The Filter; Troubleshooting - Silk'n ReVit Instructions For Use Manual

11.3 Replacing the filter

In order to replace the filter, hold the GRIP carefully detaching it from the FRONT COVER CONE. Remove the
Filter gently from its place inside the FRONT COVER CONE and dispose of it. Take a new one from the pack
and place it carfully inside the CONE.
Reattach the TIP by pushing the GRIP back gently onto the FRONT COVER CONE until they are
seamlessly alighned
Never immerse Revit™ or any of its parts in water!
This device is to be orderly disposed of when reaching End of Life stage. In this way the device' s valuable materials
are recycled and the environmental burden avoided.
Deliver your old equipment to the nearest electronic waste collection point for safe and efficient disposal.

12. Troubleshooting

"My Revit™ does not start."
Make sure the power cord is properly connected to the Revit™ device.
Make sure the power cord is plugged into an electrical outlet on the wall.
"The suction is weak"
Make sure you have good contact with the skin and that the treatment surface is evenly and firmly pressed
to the skin.
Make sure you are on FULL SUCTION mode. To check this, give the ON BUTTON a quick press. If suction
increases, you were working on PARTIAL SUCTION mode.
Make sure your fingers are not blocking the AIR VENTS. Without air going into the system, the suction
becomes slow and inofficient.
Make sure the REPLACABLE FILTER is positioned correctly inside the FRONT COVER CONE.
Make sure the REPLACABLE FILTER is not clogged by skin particles fallout. If this is the case, replace the
filter with a new one as explained in section 11.3
9