After Treating With Revit; Revit™ Maintenance; Cleaning Revit; Replacing The Tip - Silk'n ReVit Instructions For Use Manual

10. After treating with Revit™

When a Revit™ session has been completed, turn Revit™ off by giving the ON BUTTON one quick press if you
are on Full Suction Mode, or two quick presses if you are treating on Partial Suction Mode
Unplug the power cord from the electrical outlet.
It is recommended that you inspect the REPLACABLE FILTER every few treatments for skin fallout blockage. It
is also important that you clean the FILING TIP periodically.
After cleaning, it is recommended you store your Revit™ device in its original box, and keep it away from water
11. Revit™ Maintenance

11.1 Cleaning Revit™

It is recommended that you clean your Revit™ device, and especially the FILING TIP.
Unplug Revit™ before cleaning.
Use a dry, clean cloth to gently wipe the Revit™ outer shell.
In order to clean inside the TIP, separate it from the device by holding the GRIP and carefully detaching it from
the FRONT COVER CONE. The TIP is now ready for cleaning.
The FILING TIP can be cleaned with warm water and mild soap, using a soft brush. Dry thoroughly.
Reattach the TIP by pushing the GRIP back gently onto the FRONT COVER CONE until they are seamlessly alighned

11.2 Replacing the Tip

If you wish to treat your skin with a finer or coarser tip than the one currently in use, you can replace it by following
these simple instructions:
Separate current Tip from the device by holding its GRIP and carefully detaching it from the FRONT
COVER CONE.
Attach the TIP you chose by pushing its GRIP back gently onto the FRONT COVER CONE until they are
seamlessly aligned.
You are now ready to use the device with the tip of your choice
8