Connecting The Can Bus Interface - Dometic MagicSpeed CBI200 Installation And Operating Manual

Connecting the CAN bus interface

7 Connecting the CAN bus interface
I
NOTE
The configuration of the OBD-II plug can be found in fig. 6.
Supplementary to fig. 5
➤ Before installation, make sure that the output signals you require for your vehicle can be made
available by CBI200.
You can find a detailed list of vehicles at:
http://www.dometic.com/CBI200
I
NOTE
Only connect the cables to the CAN bus cables in the vehicle, which are specified in
the vehicle list.
➤ Connect the white and the blue cables with the CAN bus cables as described in the vehicle
list.
➤ Insert the plug of the connection cable into the socket of the CAN bus interface.
➤ Switch on the ignition.
✓ The status LED indicates the system status.
Status LED flashing red: vehicle search in progress
Status LED lit up green: vehicle was recognised
You can use the CAN bus interface.
Status LED lit up red: vehicle was not recognised
➤ Check whether:
– the vehicle type is included in the vehicle list
– the voltage supply is 12 V
– the CAN bus cables are connected correctly
– the CAN bus cables are detected in the right position in the vehicle (see vehicle list)
6
CBI200
EN