Using The System Components; Switching The Transmitter On; Switching The Stehoset Receiver On; Adjusting The Volume - Sennheiser MM 50 Instructions For Use Manual

Using the system components

Switching the transmitter on

Take the stethoset receiver out of the transmitter's charging
compartment
The LED lights up green.
Note:
If the receiver is placed into the transmitter's charging
compartment
The LED goes off.

Switching the stehoset receiver on

Volume up? - No!
Attention!
When people use headphones, they tend to choose
a higher volume than with loudspeakers. Listening
at high volume levels for long periods can lead to
permanent hearing defects. Please protect your
hearing, Sennheiser headphones also sound
exceptionally good at low volumes.
Turn the volume control
it clicks.
Before putting the receiver on, use the volume control
adjust the volume to a low level. This protects your hearing
from damage.
Put the receiver on the correct way round, with the
Sennheiser logo at the front.

Adjusting the volume

If the transmitter is connected to a headphones socket of
your sound source:
Adjust the volume of the sound source to a medium level.
This improves the quality of cordless sound transmission.
Use the volume control
sufficient and comfortable level.
. The transmitter automatically switches on.
, the transmitter automatically switches off.
in the direction of the arrow until
to adjust the volume to a
to
9