Advertisement
UOM board configuration
No
Name
1
LD #1
2
RS485 Communication port
relay #1 ~ #16 (Relay #1 ~
3
#16) output port
input #1 ~#2 (Input #1 ~#2)
4
port
5
LD #7 ~ #22
6
LD #23 ~ #24
7
Fixing hole
Dip switch for setting board
8
ID & ADC
9
Board ID LED
10
RESET S/W
11
Initialization Switch
Turned on LED means that power is being supplied normally.
Used when connecting iFDC/iEDC board
Provides sixteen FORM-C (COM, NO, NC) relay outputs.
(DC12~24V, Max 2A)
Consists of 2 input ports.
When an output occurs, the corresponding output
LED blinks for the output time
(LD #7 – Relay #1, LD #8 – Relay #2, LD #9 – Relay #3, LD
#10 – Relay #4, LD #11 – Relay #5, LD #12 – Relay #6, LD
#13 – Relay #7, LD #14 – Relay #8, LD #15 – Relay #9, LD
#16 – Relay #10, LD #17 – Relay #11, LD #18 – Relay #12,
LD #19 – Relay #13, LD #20 – Relay #14, LD #21 – Relay
#15, LD #22 – Relay #16)
When a normal input is received, the corresponding input
LED
blinks for a moment (LD #23 – Input #1, LD #24 – Input #2)
Can be used when fixing board to NEMA case or to Earth
Ground.
Switch for setting board ID. Board ID indicates device's own
address for communication. Switch1-2: shows applicable
board ID via LED. Switch 3: whether to use ADC.
Shows board ID
Reboot UOM. Setting values remains after the reboot.
Initializes all the values of UIM to factory default and resets
UIM. Press this switch for more than 3 seconds to initialize
the device.
7
User Manual
Description
Advertisement
