Advertisement
Caution – Board ID setting
Board ID shouldn't be duplicated as it is unique address for communication.
If same board ID exists, there can be communication error.
5.4 Power wiring
- Connect +12V cable (red) to +12 V power port of UIM board.
-Connect GND cable (black) of DC 12V power supply to GND port of UIM board.
5.5 Input device wiring
User can connect input device such as door contact sensor, exit button and other sensors to input ports
(INPUT#1~INTPUT#2).
5.6 Output device wiring
User can connect output device such as alarm to output ports (RELAY#1~RELAY#16).
(Figure: Power wiring)
11
User Manual
Advertisement
