Planar 2D-24 Installation Instructions Manual page 28

3.9.6 Heater Electrical Wiring Installation.
Installation of wire harnesses and other electrical parts of
the heater should be made according to the wiring diagram.
Install the harnesses so as to prevent their heating, deformation,
and movement during vehicle operation. Fix the harness with
plastic collars to vehicle parts.
Attention! Mounting shall be carried out with the fuse
removed.
If the length of the fuel pump wiring harness needs
to be shortened, it is allowed to remove an
unnecessary portion from the middle of the
harness. The splice should be insulated.
Installation of the fuel pump electrical harness connector is
shown in Fig.31.
28