Prior Using For The First Time; Salt Container - AEG FSE21200P User Manual

10 www.aeg.com
4. PRiOR TO uSiNg FOR ThE FiRST TiME
NOTE:
if your model have no water softener,
you may skip this section.
4.1 Loading the Salt Into the
Softener
Always use salt intended for
use with dishwasher.
The salt container is located beneath the
basket and should be filled as follows:
Attention!
• Only use salt specifically designed for
use in dishwashers! all other types of
salt not specifically designed for use in
a dishwasher, especially table salt, will
damage the water softener. in case
of damages caused by the use of
unsuitable salt the manufacturer does
not give any warranty nor is liable for
any caused damages.
• Only fill with salt just before starting
one of the complete washing
programmes. This will prevent any
grains of salt or salty water, which
may have been split, remaining of the
bottom of the machine for any period
of time, which may cause corrosion.
A. Remove the basket and then unscrew
and remove the cap from the salt
container.
B. Before first wash, add 1lt. of water in
the salt container of your machine.
C. Place the end of the funnel (supplied)
into the hole and introduce about 1kg
of salt. it is normal for a small amount
of water to come out of the salt
container.
D. After filling the container, screw the
cap tightly back clockwise.
E. usually, the salt warning light will be
cease to be illuminated within 2-6
days after the salt container has been
filled with salt.
F. Immediately after filling the salt
into the salt container, a washing
programme should be started
(Suggest choose rapid program).
Otherwise filter system, pump or other
important parts of the machine may
be damaged by salty water. it is out of
warranty.
NOTE:
1. The salt container must only be
refilled when the salt warning light
in the control panel comes on.
Depending on how fully the salt
dissolves, the salt warning light
may still be on even though the
salt container is filled.
if there is no salt warning light
in the control panel (For some
Models), you can judge when to
load the salt into the softener by
the cycles that the dishwasher
had run.
2. if there are spills of the salt, a
soak or a rapid program should
be run to remove the excess salt.
Adjusting Salt Consumption
Step 1: Enter the status of
salt adjustment
Open the door, within 60 seconds after
power on, press Programbutton and hold
for 5 seconds, the machine will enter
setting mode.