Linkage Action; Trigger Channel Tab; Arming Schedule Tab - Abus HDCC90001 User Manual

Parameter Setting
Alarm output Select the alarm output to adjust
the settings.
Alarm name Enter a clear description, e.g.
warehouse door contact
Dwell Time Select the dwell time for switching
the alarm output.
Settings Define the linkage action.

Activate the alarm output by ticking the "Settings"
box.

Define the schedule for the recorder alarm output in
the event of an alarm under "Settings".

Linkage action

The "Linkage action" menu is the recorder's central event
control function. From here, event-based recording, time
schedules, emails, acoustic warnings, CMS notifications
and PTZ actions can be programmed.
Linkage actions are available in various menus on the
recorder (e.g.: alarm, motion detection, VCA).
Note
If not further defined, use this section as a
reference for the configuration of Linkage Action
and as a substitution for all relevant menus in the
recorder.

Trigger channel tab

Tick the corresponding box to select which camera
channel is triggered in the event of an alarm.
Parameter Setting
Trigger Select which camera should be
channel
triggered in case of an alarm/incident.
A trigger signal normally causes an
alarm recording.
Arming If you wish, you can decide whether
schedule
the schedule of a camera should be
activated in the event of an incident.
This setting is only practical if the time
schedule of a camera was explicitly
deactivated beforehand (see
"Recordings" menu). Normally, the
time schedule of a camera is always
enabled.
Linkage action Here. you can configure the response
of the recorder in the event of an alarm
by ticking the corresponding box.
All actions can be enabled
simultaneously.
PTZ action Here you can control specific
PTZ presets, patrols or patterns for a
taught-in camera.

Arming Schedule tab

Setting: Configuration
35