Advertisement
INTRODUCTION
Thank you for purchasing this UFO Light source.
Please read these instructions fully before connecting your unit to the electrical supply, and keep them
for future reference.
The UFO MicroLED range of light sources utilises an RGBW LED array and is suitable for use with either
glass or polymer fibre-optic harness
This MicroLED is powered by a 100-240VAC PSU or LED Driver.
IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
TYPE Y ATTACHMENT: If the external flexible cable or cord of this luminaire or
associated PSU/driver is damaged. It shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person to avoid a hazard.
LOCATION: Do not locate this luminaire closer than 200mm from any flammable
surface.
CLEARANCE/VENTILATION: It is imperative that a gap of 200mm is left around the
unit. This is to allow air to circulate and prevent overheating. The location must
have free ventilation and must not have a ambient temperature higher than that
specified for the luminaire.
MOUNTING: This is a fixed luminaire. See separate mounting plate instructions for
fixing to surface.
WARNING: Never look directly into the Luminaire LED light source.
IMPORTANT: The luminaire should be positioned so that prolonged staring into the
luminaire at a distance closer than 0.33 m is not expected.
2
MicroLED Light Source Range
Advertisement
