Table of Contents
Advertisement
Your New Wide TV
Remote Control
You can use the remote control up to a distance of about 23 feet from the TV. When using the
remote, always point it directly at the TV. The remote control can also operate your VCR, cable box,
and DVD player.
1. POWER
16. TV/PC
Press to switch to the PC mode (when the
Turns the TV on and off.
PC is connected to your TV).
2. +100
Press to select cable channels over 100 on
17. Fav.CH (Favorite
TV.
Channel)
3. Menu
Press to switch between your favorite chan-
nels.
Displays the main on-screen menu.
18. S.Mode
4. CH(Channel) and
Adjust the TV sound by selecting one of the
VOL(Volume)
preset factory settings (or select your per-
Controls volume, channel selection.
sonal, customized sound settings.)
5. Mute
19. P.Mode
Press to mute the TV sound.
Adjust the TV picture by selecting one of the
preset factory settings (or select your per-
6. Display
sonal, customized picture settings.)
Press to display information on the TV
20. VCR controls
screen.
Controls VCR tape functions: Rewind, Play,
Fast Forward, Stop, Pause.
7. Aspect
Press to change the screen size.
21. PIP controls
Source ; Press to select one of the available
8.
Surround
signal sources for the PIP window.
Press to hear the Dolby surround effect.
Scan; Press to scan the memorized
9. MTS(Multichannel
channels.
Television Stereo)
Locate; Press to move the PIP window to
Press to choose stereo, mono or Separate
any of the four corners of the TV screen.
Audio Program (SAP broadcast).
Swap; Exchanges the video signal that is
10. Mode
currently displayed on the main screen with
the signal in the PIP window.
Selects a target device to be controlled by
the Samsung remote control (i.e., TV, VCR,
Size; Press to make the PIP window larger
Cable, or DVD).
or smaller.
11. Pre-ch
CH(PIP); Displays the available channels in
sequence. (These buttons change channels
Tunes to the previous channel.
in the PIP window only.)
12. TV/Video
22. V.chip
Press to display all of the available video
Press to set up and activate the parental
sources (i.e., TV, VCR, DVD, DTV, PC).
locks.
13. Joystick
23. Set
Used during set up of this remote control,
Use to highlight on-screen menu items and
so that it will work compatibly with other
change menu values.
devices (VCR, cable box, DVD, etc.)
14. Caption
24. Sleep
Controls the caption decoder.
Press to select a preset time interval for
automatic shutoff.
15. PIP
25. Add/Erase
Activates picture in picture.
Press to add or erase channels in the TV's
memory.
Use the Add/Erase button to
memorize/erase the optimal state of value
after fine tuning channels.
14
Your New Wide TV
Installing Batteries in the Remote Control
With normal use, the batteries in the remote control should last about a year. If you notice a perfor-
mance degradation while using the remote, the batteries may need to be replaced. Make sure you
replace both batteries and do not mix old and new batteries in the remote control. If you won't be
using the remote control for a long time, remove the batteries and store them in a cool dry place.
Slide the back cover all the
1
way out to open the battery
compartment of the remote
control.
2
Install two AAA size
batteries. Make sure to
match the "+" and "–" ends
of the batteries with the
diagram inside the compart-
ment.
3
Slide the cover back into
place.
15
Advertisement
Table of Contents
