Installation - Motorola FlexPass OFR100 Operating And Installation Manual

FlexPass OFR100

6. Installation

6-1. Mullion/Wall Mount
Drill two 6-32 or M3 holes 3.3"(8.38cm) apart in vertical and drill one 1/2" hole for
the reader cable 1.7"(4.31cm) apart from the top hole.
(If you have installed an electric gang box then skip this step and go to step 6.2.)
6-2. Put reader cable into the center hole and install the reader module by using two
6-32 or M3 screws (Not included).
6-3. Put bezel on to the reader module then push bezel until you hear the locking sound.
6-4. To detach the bezel, hold both sides of the bezel, push the bezel to the bottom, and pull
the bezel forward.
K02000-000 - 5 - 06/29/01