Download Print this page

Advertisement

Quick Links

CONGRATULATIONS ON PURCHASING YOUR
TOTALLY WICKED SKOPE P ELECTRONIC CIGARETTE KIT
USING YOUR SKOPE P
Filling the Cartridge
Remove the cartridge by pulling straight out of the
Skope P. Locate the rubber flap on the side of the
cartridge, and lift the edge marked with an arrow
symbol. With the filling hole now exposed, insert your
e-liquid bottle nozzle fully, and fill to leave a minimum
air gap of approximately 2mm. Close the filling point
and reinsert the cartridge firmly into the Skope P.
1
2
Vaping:
Simply inhale gently on the cartridge mouthpiece of the Skope P and it will
begin to produce vapour. The LED in the centre of the device will illuminate
while the device is activated.
Battery Level Indication:
Approximately one second after you
finish inhaling, the LED will relight
to show the battery's approximate
remaining charge as detailed in the
table opposite.
Charging the Battery
To charge the battery, connect the USB cable into the charging port on the side
of the Skope P. The LED will glow until fully charged, at which point it will turn
off.
3
Note: After filling a new cartridge, it
is recommended to wait 5 minutes
to ensure the atomizer head is fully
saturated.
USER MANUAL
Cartridge
LED
Battery
LED
Percentage
Condition
100-50%
Stays green
49-20%
Stays red
19-1%
Flashes red
Filling
Point
Charging
Port

Advertisement

loading
Need help?

Need help?

Do you have a question about the Skope P and is the answer not in the manual?

Questions and answers

Summary of Contents for Totally Wicked Skope P

  • Page 1 19-1% Flashes red Charging the Battery To charge the battery, connect the USB cable into the charging port on the side of the Skope P. The LED will glow until fully charged, at which point it will turn off.
  • Page 2 Short Circuit Protection PRODUCT STORAGE AND BATTERY If a short circuit occurs before you PRECAUTIONS inhale on the Skope P, the LED • Store the Skope P and its will flash continuously. Changing accessories away from children the cartridge should allow normal when not in use.