Totally Wicked switz2 User Manual

Congratulations on purchasing your
Totally Wicked Switz2 Electronic Cigarette Kit
The Totally Wicked Switz2
Mouthpiece
E-liquid Viewing Window
Tank
Power
Button
USB Charging Port
Battery

Using your Switz2

Priming the Atomizer Head:

Turn the Switz2 kit upside down so the
mouthpiece points downwards. Unscrew and
remove the battery from the tank. Grip the
atomizer head by its connector and remove it
from the tank by pulling. Prime the atomizer
head by dripping a few drops of E-liquid into
the central hole of the atomizer head. After
priming the atomizer head, insert it back into
the tank and screw the battery back on.

Filling the Tank:

Unscrew the top cap from the tank. Fill the
tank to the top of the e-liquid viewing window,
avoiding filling down the central airflow
hole. Once filled, screw the top cap back on.
Note: After priming a new atomizer head
and filling the tank, it is recommended to
wait 5 minutes to ensure the atomizer head
is fully saturated.
(1)

Powering On And Off:

To turn the Switz2 on, press the power button
five times in quick succession, the indicator
light will flash purple three times to show the
Switz2 has been switched on. Similarly, if the
Switz2 is already turned on, press the power
button five times in quick succession to turn
the Switz2 off, the indicator light will flash
purple three times.

Vaping:

Press and hold the power button as you inhale
the vapour, the indicator light will illuminate
while the power button is held down to vape.
Atomizer
Head

E-liquid Viewing Windows:

The Switz2 tank has three E-liquid viewing
windows, these enable you to see at a glance
how much e-liquid is left in the tank. Ensure
the E-liquid level does not go lower than the
bottom of the viewing window to prevent
the atomizer head from becoming dry and
burning prematurely.

Charging The Battery:

The Switz2 is recharged by inserting the
charge lead into the charge port located to
the right of the power button. The indicator
light will flash three times when the charge
lead is first connected, the indicator light will
illuminate red and remain on while charging.
Once fully charged, the indicator light will turn
off completely.

Installing/Replacing an Atomizer Head:

To install a new atomizer head follow the
process shown in the "Priming the atomizer
head" instructions above.
Reminder: After priming a new atomizer
head and filling the tank with e-liquid, it is
recommended to wait 5 minutes to ensure
the atomizer head is fully saturated with
e-liquid.

Battery Life Indication:

As the level of battery charge changes, the
indicator light will change colour to represent
the amount of remaining battery life.
(2)