DeWalt D55154 Instruction Manual page 15

CODE POssiBlE CAUsE
16 Engine or pump oil is low
17 Carbon build-up in pump.
18
Detergent type oil being used in pump
19 Motor overload protection switch has tripped
20
Extension cord is wrong length or gauge
21 Loose electrical connections
22 Possible defective motor or starting capacitor
23 Paint spray on internal motor parts
24 Fuse blown, circuit breaker tripped
25 Tank pressure exceeds pressure switch cut-in pressure
26 Pressure release valve on pressure switch has not unloaded
head pressure
POssiBlE sOlUTiOn
Add same type of oil in crankcase to pump. See Compressor Pump Oil
under Maintenance.
Contact a D WALT factory service center or a D
e
Drain oil and refill pump using SAE 5W-40 full synthetic oil.
See Motor Overload under Components.
Check for proper gauge wire and cord length. See Extension Cords
under Assembly and Adjustments.
Contact a D WALT factory service center or a D
e
Contact a D WALT factory service center or a D
e
Contact a D WALT factory service center or a D
e
not operate the compressor in the paint spray area. See flammable vapor warning.
Check fuse box for blown fuse and replace as necessary. Reset circuit breaker. Do
not use a fuse or circuit breaker with higher rating than that specified for your
particular branch circuit.
Check for proper fuse. Use only a time delay fuse.
Check for low voltage conditions and/or proper extension cord.
Disconnect the other electrical appliances from circuit or operate the compressor on
its own branch circuit.
Motor will start automatically when tank pressure drops below cut-in pressure of
pressure switch.
Set the On/Off switch to OFF. If the valve does not open, replace switch. Contact a
D WALT factory service center or a D
e
English
WALT authorized service center.
e
WALT authorized service center.
e
WALT authorized service center.
e
WALT authorized service center. Do
e
WALT authorized service center.
e
13