Advertisement
8. Pull the native 18.3 m (60 ft) Luminaire cable to a power/data supply. If necessary,
you can extend the cable using 18 AWG, 3-conductor stranded copper wire to
a maximum length of 45.7 m (150 ft). The total cable length for each power/data
supply cannot exceed 121.9 m (400 ft).
9. Repeat steps 1 through 8 for each Luminaire in the installation.
Make Power Connections
Make sure the power is OFF before mounting and connecting ColorBurst 6
Luminaires.
1. Pull each Luminaire cable through a knockout in the side of the power/data supply.
2. Connect line, common, ground, and data to a provided connector, then snap the
connector into the connector terminal inside the power/data supply housing.
R
W
B
3. Using wire nuts, connect the green ground wire from each Luminaire cable to the
earth ground on the power/data supply,
PDS-60
4. Repeat for each power/data supply in your installation.
12
ColorBurst 6
Product Guide
Luminaire cable dimensions
PDS-150e
9.5 mm
18 AWG
(0.375 in)
1 mm (0.04 in)
Advertisement
