Everpure Insurice PF Single Manual

EVERPURE
EVERPURE
®
Insurice PF Single 7SI System
SELECTING A LOCATION
1. Give consideration to the weight of the unit when operating (filled with water). Operating weights of the Insurice PF
Systems are:
• Insurice PF Single - 7SI - 16 lbs (7.26 kg)
• Insurice PF Twin - 7SI - 29 lbs (13.15 kg)
2. The location should allow for:
• Minimum clearance of 2
• Adequate space for "in" and "out" water line connections.
• Be near a drain for flushing and near a 110V outlet if the accessory (sold separately) Everguard™ Low Pressure Alarm is
used. See Step 5.
OPERATING SPECIFICATIONS
• For cold water use only.
• Operating Temperature: 35 – 100°F (2 – 38°C)
• Min.-Max. Working Pressure: 10-125 psi (0.7-8.6 bar), non-shock
• Flow Rate:
System
Insurice PF Single – 7SI
Insurice PF Twin – 7SI
Insurice PF Triple – 7SI
Insurice Quad PF - 7SI
INSTALLATION INSTRUCTIONS
1. Use the predrilled mounting holes in the manifold bracket as guides. Mark and drill anchor holes. Mount securely. See
Figures 1 – 4 .
2. Shut off power to equipment.
3. Connect outlet port of the Insurice PF System to equipment served. Always use an NSF approved pipe dope or Teflon
tape at all connections. Use a backup wrench on all fittings while connecting to avoid excessive stress on the system
components.
4. Install a manual shut-off valve leading to the system for servicing.
5. Connect minimum 3/8" water line to the Insurice PF Single System inlet. Use a minimum 1/2" for Insurice PF Twin, Triple
and Quad Systems.
6. Connect tubing to flushing valve and run to drain. The cross fitting has a flushing valve installed
on the bottom.
Note: Some municipal plumbing codes and good sanitary practices require an air gap at the
drain termination point.
FILTRATION & PROCESSING SOLUTIONS
7SI INSURICE
®
Insurice PF Twin – 7SI System
⁄ " under the cartridge(s) so it can be lowered for removal and replacement.
1
2
Replacement Cartridge Flow Rate
7SI 3.5 gpm (13.25 Lpm)
7SI 7.0 gpm (26.50 Lpm)
7SI 10.5 gpm (39.75 Lpm) 75,000 gal. (283,906 L)*
7SI 14.0 gpm (53.00 Lpm) 100,000 gal. (378,541 L)*
7SI INSURICE PF SYSTEMS INSTRUCTION & OPERATION GUIDE
PF SYSTEMS
®
Insurice PF Triple – 7SI System
• Insurice PF Triple - 7SI - 37 lbs (16.79 kg)
• Insurice PF Quad - 7SI - 43 lbs (19.50 kg)
Capacity
25,000 gal. (94,635 L)*
50,000 gal. (189,271 L)*
*As tested by Everpure
Insurice PF Quad – 7SI System
®
Air Gap