Loading A Disc; Normal Play - Sanyo MCD-Z160F Instruction Manual

Hide thumbs Also See for MCD-Z160F:
Table of Contents

Advertisement

Both 8cm and 12cm discs can be played in this unit.
NOTE:
Place only one disc at a time in the CD compartment.
-
Only disc bearing the logo in Fig.3 can be played in this unit
Handling
compact
discs
Always place the compact disc in the CD compartment
with the label facing upward.
Compact discs can be played on only one side.
Fingerprints
and dust should be carefully wiped off the disc's signal sutiace (opposite the labeled
side) with a soft cloth, Gently wipe in a straight motion from the inside to the outside of the disc.
Discs should be returned to their cases after used to avoid serious scratches that could cause the
player to skip,
Do not expose a disc to direct sunlight, high humidity, or high temperatures
for extended periods of
time to prevent warping the disc.
Do not stick paper or write anything with a ballpoint pen on a disc.
Do not use cleaners or antistatic sprays on discs, like those used for phonograph
records.
LOADING A DISC
1.
Set [FUNCTION]
to CD.
'f - " lights,
2,
Press [CD OPEN]. The lid will open.
3.
Place a disc carefully on the turntable in the CD compartment,
with the label side facing up (Fig.4).
4,
Close the lid.
[CD TRACK NO.] will show the total number (max.19 ) of tracks on disc.
NOTES:
If a disc is loaded upside down, or if no disc is loaded, the CD player will not operate.
-
Opening the CD compartment
lid while a CD is played could scratch the disc. Always press [STOP/
CLEAR] and wait for the disc to stop rotating before opening the CD compartment
lid.
NORMAL
PLAY
1.
Press [PLAY/PAUSE].
Play will begin with track number
1. [CD TRACK NO.] will show the track
number.
NOTE:
To start play from the designated track, press [
>1 SKIP/SEARCH]
until desired track number
is indicated and track number will flash. Then press [PLAY/PAUSE]
Play will start from the se
Iected track,
2.
Adjust [VOLUME],
[TONE] and [BASSXPANDER]
as desired.
3.
Press [STOP/CLEAR]
to stop play at any time.
When the last track has played, the CD player will automatically
stop.
Pause
1,
Press [PLAY/PAUSE]
during play.
Play will temporarily
stop, [CD PLAY] will flash,
2,
Press [PLAY/PAUSE]
again to resume play. The (CD PLAY) will remain on.
-6-

Advertisement

Table of Contents
loading

Table of Contents