Troubleshooting; Fcc Information To User - Magicsing ET21KV User Manual

Additional Information - Chapter.06

TROUBLESHOOTING

TROUBLESHOOTING
In case of problems, please check the following recommendations before
contacting the service center.
If MagicSing doesn't power up
ET21KV MAIN STATION
Make sure the adaptor is correctly plugged into the power outlet.
Check that the male plug is properly inserted into the female jack.
WIRELESS KARAOKE
Check if the battery type is AA. If the battery is low, MagicSing may not
work properly.
If the user's voice cannot be heard
Press the VOL button and check the volume of the wireless karaoke.
If the TV does not show pictures or emit sound
Make sure all the AV connectors are properly connected according to the
correct colors. Check if the TV is in the video mode.
If the video does not show properly (converting PAL or NSC mode)
To convert to PAL mode, turn off a wireless mic first. Press and hold button "8" on the
wireless mic, and then press "POWER" button using another finger until the word "PAL"
appears on the TV screen. (Do not release button "8" and the "POWER" button until the
word "PAL" appears on the TV screen.) To convert to NTSC mode, turn off a wireless
mic first. Press and hold button "9" on the wireless mic, and then press the "POWER"
button using another finger until the word "NTSC" appears on the TV screen.
(Do not release button "9" and the "POWER" button until the word "NTSC" appears on
the TV screen .)
If there is any doubt about the product's performance
Turn off a wireless mic first, and then press and hold the "0" button on the
wireless mic, and press the [POWER] button using another finger until the words
"USER RESET" appear on the TV screen. (Do not release the "0" button and
the [POWER] button until the words "USER RESE￠pear on the TV screen)
When the wireless karaoke needs to be repaired, the main station
should be included and returned to your nearest service center.
To contact our nearest service center in your area,
please visit our website. "www.enter-tech.com"
|
CHAPTER. 06
02
VER.100
Chapter.06 - Additional Information
FCC Information to User ( For U.S. territory )
This equipment has been tested and found to comply
with the limitsfor a Class A digital device, pursuant
to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case
the user will be required to correct the interference
at his own expense.
Caution
Modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) the device may not cause interference, and
(2) the device must accept anyinterference,
including interference that may cause undesired
operation of this device.
|
03 CHAPTER. 06
VER.100