Setting The Remaining Time - Sears 934.5512559 Owner's Manual

SETTING THE REMAINING TIME
You can set the remaining tape running time of your tape.
• If your cassette tape length is T- 130 or less, select "~T 130". For example, the popular T- 120 cassette tape calls
for the "~Ti 30" selection. If your cassette tape is T-140 or greater, select "T140-". Then the tape remaining
indication will be correct.
NOTES:
• VCR Power must be on.
• Turn on the TV and set the TV channel to the same video output channel located on the back of the VCR.
(CH 3 or 4)
• Press the TV/VCR button so that "VCR" appears on the display.
• You must use remote control for this procedure.
FT1
Press MENU button. Select
item 2(VCR SET UP) with
number buttons.
Select "-TI 30" or 'q'l 40~"
with 1 button.
Press MENU button to re-
turn to normal mode.
MENU ]
1 11MER PROGRAMMING
VCR SET UP
3 INITIALIZE
i ........ t
TAPE SELECT ~T1
REPEAT PLAY
RENTAL
To check the remain time, /'_'Y"
1
press SELECT button on the /
remote control unit until RE-
MAIN appears on TV
screen.
,o REM _,,N .... T,30
Notes:
REMAINING TAPE RUNNING TIME
DISPLAY
• Since the reel diameter and tape thickness are not
common to all cassettes, the time count differs from
cassette to cassette. Use the time display as an infor-
mative number only.
• During recording, the remaining tape running time
is estimated based on the current recording mode
(SP, LP, SLP).
• During playback the remaining tape running time is
calculated based on the current playback mode.
• Remain time will not appear on TV screen while in
the Fast forward or Rewind Mode.
• There will be a delay of up to 1 minute before the
remain time appears on the TV display.
Note:
The use of the following tapes will result in difference
between the displayed remaining time and actual time
to the end of the tape:
• Tape housed in a VHS-C cassette adapter.
• Shorter tape length such as a 10-minute cassette
• T-180 cassette. In this case the display may read 2
Hours, 40 Minutes at the start point of the tape in SP
mode.
• In the Remain Time Mode calculating will start
when the cassette tape is inserted and PLAY button
is pressed.
While calculating, the TV screen shows as illus-
trated.
• A video cassette must be inserted in the VCR for this
function to work.
- 27 - EN
** €__r_ 5B24