Advertisement
Available languages
Available languages
•
WARNING
Electrical
Shock Or Personal Injury
Hazard
Disconnect
electrical
supply before
servicing
or cleaning the unit.
Failure to do so could result
in elec-
trical shock or personal
injury from
cleaner suddenly
starting.
TO CHECK BRUSH:
when
brushes
are worn to the
level of the base
support bars,
replace the
brushes
Base Support Bars
TO REPLACE BRUSH:
1. Remove POWER-MATE
TM
cover, belt and
brush assembly. See "To remove belt" in
BELT CHANGING
AND BRUSH
CLEANING.
2, Remove brush supports, washers,
screws, end brush, brush sprocket pieces
from ends of brush assembly.
3, Push out worn
brushes. If the
beater bar is
chipped or
gouged,
replace iL
4. Slide new
beater bar and
brushes into slots°
NOTE: New
brushes and
beater bar may
be easier to install
if they are soaked
in warm water for
a few minutes.
Dry thoroughly
before installing
5. Reassemble
brush assembly. To line up
screw holes in dowel, sprocket and end
brush, be sure beater bar portion of end
brush lines up with beater bar on brush
dowel.
6. Replace belt, brush assembly,
POWER-
MATE
TM
cover, light bulb and light cover. See
"To replace belt" in BELT CHANGING
AND
BRUSH CLEANING.
Brush
Sprocket
Flan
Brush Dowel
Brush
Sprocket
End
Brush
Brush
I
Suppo_
Washer
16
Advertisement
