Advertisement
TEST FOR SOLUTION SPRAY
See Figure 6
1. Hold Floor Nozzle
above floor level.
2. Pull Solution Release Trigger on Angled Wand.
3. Observe Floor Nozzle
to make sure cleaning solu-
tion is being sprayed
evenly.
(see DETAIL "A" )
NOTE: If solution
is not being sprayed
evenly, refer to
Trouble Shooting Chart.
CLEANING THE CARPET
See Figures 7 & 8
Solution
Dispensing
Stroke:
1. Start at a corner (recommended).
2. Place Floor Nozzle
so Suction Inlets are flush with
carpet.
3. While
exerting
light
pressure
down
on Floor
Nozzle, depress Solution Release trigger and slowly
pull Floor Nozzle towards you.
NOTE: Do not overwet. If three or more cleaning strokes
are required,
let dry and then repeat cleaning process.
Solution
Recovery
Stroke:
1. Release Solution
Release Trigger.
2.
Lift Floor Nozzle off carpet.
3. Return Floor Nozzle
to point where you dispensed
cleaning solution and pull across carpet, recovering
dirty solution,
SUCTION INLETS
LIFT,
SET FORWARD,
PULL BACK ACROSS CARPET
,
\
_
.
_ . =
Advertisement
