J-Dream Packaging - Jacuzzi J-DREAM Owner's Manual

J-Dream Owner's Manual
Electrical requirements
Your J-Dream, as it comes from the factory, requires a GFCI protected 220/240 VAC 15 AMP 3-wire circuit (2 conductor with
ground) for single (1) phase electrical service, and must be in a separate circuit having no other appliance connected in that
circuit. If you do not have this kind of circuit, a qualified electrician should be called in to install the necessary wiring.
Inadequately sized wiring or locating the unit too far from the main service panel may cause a voltage drop. A drop in voltage
can cause the unit to malfunction and bring about permanent damage to the shower's electrical system. The circuit ground
wire must be provided to take advantage of the designed-in safety features of the J-Dream. Bond according to procedure
described on page 23. Caution: Without proper grounding and bonding, a system malfunction may cause fatal
shock.
Electrical precautions
Lighting and electrical receptacles must be located at least 5 ft (1.5m) from the J-Dream. Lighting located between 5 ft and
10 ft (1.5m and 3m) from the J-Dream must be on a circuit protected by a GFCI. Do not use electrically connected devices,
such as television, radio, telephones, stereo speakers, lights or cooking devices within 5 feet of the J-Dream while it is in
use.
Ventilation
Water which drips on the floor during exit from the J-Dream may cause a walking hazard and/or structural damage unless
proper waterproof building materials are used in the area surrounding the unit. Take into consideration, also, the high room
humidity which will exist due to use of the steamer. Providing natural or forced ventilation of the room will help maintain
comfort and minimize moisture damage to the building. Jacuzzi Whirlpool Bath is not responsible for damages resulting from
excess moisture or water spillage. Consult an architect or engineer for aid in designing your installation.
Maintenance
Cleaning the J-Dream
To clean your J-Dream, simply use a mild non-abrasive liquid detergent or commercially prepared bathtub cleaners. Do not
use abrasive cleaners. Protect and restore the gloss to a dulled surface by applying a plastic polish specifically designed
for use on acrylic finishes (methylmethacrylate). If an acrylic polish is not available, an automotive paste wax will do.
Repairs to the surface
Minor scratches which do not penetrate the color finish (acrylic) can be removed with 600-grit wet/dry sandpaper. Restore
the glossy finish with an acrylic polish or a comparable automotive paste wax. Major scratches or gouges which penetrate
the acrylic surface will require refinishing. Ask your dealer for special instructions.
J-Dream packing
Six (6) cartons packed together on a wooden pallette.
Contents of cartons
• Wall Panels
• Door Frame
• Base/Cover(includes product accessory pack and owner's manual)
• Back wall
• End Panel
• Equipment/Seat Wall
4