RCA HSDB2 Installation Manual page 7

8
Remove the faceplate from the video doorbell
nsert
illed
th the
ng the
Connect the video doorbell to home power
9
(OPTIONS A & B)
IF YOU DON'T HAVE A CHIME BOX
You must use the resistor provided in this package to
connect the video doorbell to your home's wiring. Follow
the instructions for OPTION B on the next page, including
the resistor instructions in the red box.
Before you mount it, take the faceplate
off the video doorbell—you'll need
access to several items behind the
faceplate during setup.
OPTION A: If your home's doorbell power wires are long enough
Terminals
Use the screwdriver provided in this package
to loosen the terminal screws on the back of
Loosen
the video doorbell.
Doorbell
camera
back
Terminals Connect the doorbell power wires directly
to the terminals on the back of the video
doorbell. Loop each wire end around each
terminal on the back of the video doorbell.
Note: It doesn't matter which wire you put on
Home
which terminal.
doorbell
wires
Tighten the screws to hold the wires firmly in
place.
Tighten
IMPORTANT! Handle the video doorbell carefully! Make
sure not to scratch its lens.
continues on the next page...
7