Connect And Mount The Video Doorbell - RCA HSDB2 Installation Manual

CONNECT & MOUNT THE VIDEO DOORBELL
1
Make sure the power to your doorbell's circuit is off
Find the breaker that controls the
circuit for your doorbell. Make
sure it's off before you continue
installation.
2
Remove your existing doorbell
Carefully remove your existing
doorbell from the wall. Then
unhook your home's wiring from the
Remove &
doorbell's terminals.
unhook
3
Find the mounting plate option that works best
Try the three mounting plate options
where you want to mount the video
doorbell. Choose the one that gives
you the position and angle you want
for your video doorbell.
4
Insert the bubble level into the mounting plate
Snap the bubble level into the slot on the
front of the mounting plate you want to use.
5
Position the mounting plate and mark location
Place the mounting plate where
you want to mount it. Make sure
that...
(1) the center of the plate is over
the hole where your home's
doorbell wiring comes out,
and
(2) the mounting plate is level
Use a marker or pencil to mark the top and bottom holes. Then
take the mounting plate down.
continues on the next page...
5