Free Arm Sewing; Choose The Needle; To Change The Needle; Set Up The Machine ....................... 5 - Kenmore 385. 11607 Owner's Manual

Set Up the Machine (Continued)
o Free-Arm Sewing: the Removable
Extension Table
f
To Remove the Extension Table
(for free-arm sewtng)
1. Grip the tabJe with your index finger
and thumb, as shown.
2. Pull gently to the left. The extension
table will snap out.
To Attach the Extension Table
(for fiat-bed sewing)
1. Insert the tab and the pin into thetr
catches,
2. With your thumb and index finger,
gently snap in,
o Accessory Storage Box
\
The lid of the accessory storage
box lifts open toward you.
Sewing accessoMes are conveni-
ently located in the box.
SECTION 2.
o Change the Presser Foot
....... J
_se the correct presser foot for
the stitch you wish to sew.
To change the varfous presser
feet, raise the presser bar to its
highest position by lifting the
presser foot lever.
Loosen the presser foot thumb
screw, choose the proper foot,
insert from the bottom.
Tighten the screw using the
large screw driver to make
certain the foot _s secure.
PREPARE THE MACHINE FOR SEWING
Choose the Needle and Thread
= To Change the Needle
Fiat
side
away
from
you
NOTE:
Needle clamp screw
Raise the needle bar to its highest
position by turning the hand wheel
toward you,
1, Loosen the needle clamp screw by
turning it toward you,
2. Remove the needle by pulilng it down-
ward.
3. Insert the new needle into the needle
clamp with the flat side away from you.
4. Push the needle up as far as it will go,
5. Tighten the needle cfamp screw firmly
with the large screwdriver from the
accessory box.