How To Remove Parts - Hitachi R-SF62CMJ How To Use Manual

HOW TO REMOVE PARTS

● Make sure no stored items remain before removing a part.
Notice
● Do not remove parts which are not described below.
Contact with a service center listed on the back cover for cleaning parts after removing them.
4 level adjustment shelf
● Slightly lift the shelf up and slide it forward.
Push in the shelf as far as it will go to place.
Caution
Make sure the shelf has been placed in a horizontal position.
Check the shelf to see that it does not come off when sliding it forward.
Vacuum Case (with the door)
● Pull the door, lift the Vacuum Case
with a door at the edge of it lightly,
and then pull it out, jiggling it up and
down. For more information.
● Lift up the door pocket while tapping
the left/right of its bottom surface, and
remove it. (It is fi xed a little tightly.)
Insert the door pocket fully to the end when installing it.
Height adjustable upper and middle shelf
Slightly lift up the back
1
of the shelf and draw it.
When installing the shelf, slide it until it reaches to the interior wall, then slightly lift up the back of
the shelf and push it in. (hitch the forks of the shelf to the parts on the back of the shelf)
Caution
Door may damage if drawing the shelf without turning it.
Lower Freezer (Slimline slide case, slide case and lower freezer case)
Draw the door fully, and draw the Slimline slide case and the Slide case respectively.
1
Slimline slide case
Slide case
Vegetable Compartment (Spacious Upper Case, Lower Case)
Spacious Upper Case
1
● Draw the door fully and pull
up the Spacious vegetable
case as shown in the fi gure.
48
Pg.39
Door pocket
Raise the shelf as shown in fi gure,
2
and turn it and remove it.
Forks of the shelf
Pin (right and left)
Fork (right and left)
Rectangle hole
in the frame
2
● Lift up the front part of
the door, and draw it
further and incline it.
If the lower case is not
removed as shown in
Step , remove the
3
door and then remove
the lower case. For how
to remove the door, see
Pg.48 .
● Draw the shelf, and pull off the two pins
on the lower right and remove it.
Only: R-SF62CMJ,R-SF58CMJ
Height adjustable lower shelf
● Slightly lift up and pull out.
Only: R-SF62CMJ,R-SF58CMJ
Tap
Tap
When installing it, insert the pins
on the left/right of the Lower
freezer case into the square holes
on the frame to install it.
Moreover, hitch the pins on the
left/right of the Slide case to the
outside of the Lower freezer case.
3
Lower Case
● Lift up the Vegetable Case
toward you.
● When installing it, insert the
pins on the left/right inner
sides of the Vegetable Case
into the square holes on the
frame, and put the edge of the
Vegetable Case on the frame
to install it.
Fixed shelf
Only: R-SF52CMJ, R-SF46CMJ
Form (Two
locations)
Only: R-SF52CMJ, R-SF46CMJ
Ice Compartment/ Upper Freezer
● Draw the door fully and lift
up the case towards you.
Put the case bottom on the
frame and set the case.
Lift up the Lower freezer
2
case.
Lower freezer case
Frame
■ How to install the slide door
Ice Compartment/Upper Freezer
Vegetable Compartment/Lower Freezer
Form (Two
locations)
Frame
Frame