Operation - Craftsman 580.761652 Owner's Manual

CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CAN-
,_ NOT CONTACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP,
TRANSPORTING, ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER,
CAUTION: Before using this product, I
read this manual and follow all Safety
Rules and Operating Instructions,
OPERATION:
• Do not spray flammable liquids.
o Never allow any part of the body to come in contact with
the fluid stream. DO NOT come in contact with a fluid
stream created by a leak in the high pressure hose,
• High pressure stream of fluid that this equipment can pro-
duce can pierce skin and its underlying tissues, leading to
serious injury and possible amputation.
. Never aim the gun at people, animals or plants.
• High pressure spray can cause paint chips or other parti-
cles to become airborne and fly at high speeds.
• Always wear eye protection when you use this equipment or
when you are in the vicinity where the equipment is in use.
• Operate the pressure at no more than the PSi fluid pres-
sure rated for your pressure washer.
• Never move the machine by pulling on the high pressure
hose. Use the handle provided on the top of the unit.
• Always be certain the spray gun, nozzles and accessories
are correctly attached,
o Never use a spray gun which does not have a trigger lock
or trigger guard in place and in working order
• Use a respirator or mask whenever there is a chance that
vapors may be inhaled. Read all instructions with the mask
so you are certain the mask will provide the necessary
protection against inhaiing harmfut vapors.
• High pressure spray may damage fragile items including
glass. Do not point spray gun at glass when in the jet
spray mode.
• Keep the hose connected to machine or the spray gun
while the system is pressurized. Disconnecting the hose
whife the unit is pressurized is dangerous.
• Hold the spray gun firmly in your hand before you start the
unit. Faitura to do so could result in an injury from a whip_
ping spray gun. Do not leave the spray gun unattended
whife the machine is running.
• The cleaning area should have adequate slopes and
drainage to reduce the possibility of a fali due to slippery
surfaces.
. Keep water spray away from electric wiring or fatat electric
shock may result.
• Do not adjust unloader valve to a pressure in excess of
machine rating.
• Do not secure trigger gun in the pull-back (open) position.
• Do not by-pass any safety device on this machine.
• The muffler and engine heat up during operation and
remain hot immediately after shutting it down. Avoid con-
tact with a hot muffler or engine or you could be severely
burned.
TRAINING:
• Engine exhaust gases contain DEADLY carbon monoxide
gas. This dangerous gas, if breathed in sufficient concen-
trations, can cause unconsciousness or even death.
Operate this equipment only in the open air where ade-
quate ventifation is available.
° Gasoline is highly FLAMMABLE and its vapors are
EXPLOSIVE. Do not permit smoking, open flames, sparks
or heat in the vicinity while handling gasoline. Avoid
spilling gasoline on a hot engine. Allow unit to cool for 2
minutes before refueling. Compty with nil laws regulating
storage and haedling of gasoiine,
= Locate this pressure washer in areas away from com-
bustible materials, combustible fumes or dust.
• The high pressure equipment is designed to be used with
Sears authonzed parts onty. If you use this equipment with
parts that do not comply with minimum specifications, the
user assumes all risks and liabilities.
° Some chemicals or detergents may be harmfut if inhaled
or ingested, causing severe nausea, fainting or poisoning.
The harmful efements may cause property damage or
severe injury.
• Do not allow CHILDREN to operate the Pressure Washer
at any time.
PREPARATION:
• Operate engine only at governed speed. Running the
engine at excessive speeds increases the hazard of per*
sonat injury. Do not tamper with parts which may increase
or decrease the governed speed.
,' Do not wear loose clothing, jewelry or anything that may
be caught in the starter or other rotating parts.
• Before starting the Pressure Washer in cold weather,
check all parts of the equipment and be sure ice has not
formed there.
• Units with broken or missing parts, or without protective
housing or covers shoutd NEVER be operated.
° The muffler and air cleaner must be installed and in good
condition before operating the Pressure Washer. These
components act as spark arrestors if the engine backfires.
• Check the fuel system for leaks or signs of deterioration
such as chafed or spongy hose, loose or missing ctamps
or damaged tank or cap. Correct all defects before operat-
ing the Pressure Washer.
MAINTENANCE AND STORAGE:
* Operate and store this unit on a stable surface.
. High pressure hose can develop leaks from wear, kinking,
abuse, etc. Water spraying from a leak is capable of inject-
ing material into skin.Inspect hose each time before using
it. Check all hoses for cuts, ieaks, abrasions or bulging of
cover, or damage or movement of couplings. If any of
these conditions exist, replace hose immediately. Never
repair high pressure hose. Replace it with another hose
that meets minimum pressure rating of your pressure
washer.
i A LOOK O T"'SS OBOLTO PO'"TOOT,OPOOTA l
IT MEANS "ATTENTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED."
3