Remote Id Setup Mode - Denon AVR-1612 Service Manual

3. Remote ID Setup mode

3.1. Specifications
When using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiver
operates.
2.2. Setting the AV receivers
Starting up:
Press and hold both "STATUS" and "iPod system 2 " buttons for over 3 second with the power turned on.
(1) When Remote ID Setup mode is started, the following is displayed.
FLD
(2) Press the "QUICK SELECT 1 - 4" button that corresponds to the number you want to set.
Button
QUICK SELECT 1
QUICK SELECT 2
QUICK SELECT 3
QUICK SELECT 4
(3) Turn off the power using "ON/STANDBY" button.
(4) Turn on the power using "ON/STANDBY" button.
When Remote ID Setup mode is running, operations other than the "QUICK SELECT 1 - 4" buttons or "ON/
b
STANDBY" buttons on the main unit are not received.
2.2. Setting the Remote control unit
(1) Press the "AMP" button.
The zone mode indicator flashes twice.
(2) Press the "QUICK SELECT 1, 2, 3 or 4" button.
The zone mode indicator flashes twice.
NOTE:
If the IDs do not match, "AVAMP z " ( z is the main unit's remote control ID) appears on the display when the remote
control unit is operated.
R E M O T E
R E M O T E
R E M O T E
R E M O T E
R E M O T E
I D ?
FL Display
I D 1
I D 2
I D 3
I D 4
19