Advertisement
the Drinkwater is set by App. When the time reaches the reminder of Drinkwater, the fine needle
moves between 4 o'clock and 5 o'clock, while the watch vibrates. After the vibration stops,
the fine needle points to the middle position, until after 60 seconds, At 12, the fine needle
returns to the position pointing before. Any key can quit reminding.
（21）
Count-Down timer reminding：
In normal mode, if the watch is in a pair connection with the cell phone, Count-Down timer is
set by App, and when the time reaches the reminder of Count-Down timer, the big second pin points
forward to the position of 12, and then continues to point forward the position between 5 o'clock
and 6 o'clock, and wiggle for 1 second around the position of this point, and After shaking
for about 15 seconds, until 60 seconds, the big second hand will recover the internal time.
Any key can quit reminding.
（22）
Pill Reminder reminding
In normal function mode, if the watch and the mobile phone are in a paired connection state,
the Pill Reminder is set by App. When the time reaches the reminder of the PillReminder, the
fine needle points to the position between 4 o'clock and 5 o'clock, while the big second hand
points forward to the position of 12, and then continues to indicate a few reminding to the
point. The position wobble before and after two seconds, and vibrate for about 15 seconds, until
60 seconds later, 12, when the fine needle returns to the position before pointing, the large
second pin to recover the internal time. Any key can quit reminding.
（23）
ALARM reminding：
In normal mode, if the watch and the phone are in a pair connection state, the Alarm is set
by App. When the time reaches Alarm, the big second pin points forward at 12 position, then
continues to point forward the position between 6 o'clock and 7 o'clock. After 60 seconds, the
big second pin goes back to the internal time. Any key can finish this reminder and remind it
again after 5 minutes of sleep.
（24）
OTA：
A) the big second needle goes to 12 when it is pulled out of the Raba.
B) press the S1 for about 10 seconds, the watch vibrate once and enter the OTA mode.
C) push into Rabba to wait for OTA to complete, or to exit OTA mode in timeout.
（25） clearing internal data (including time, Bluetooth pairing data).：
Pull out the Rabba, press S2 for about 20 seconds until 6, the fine needle stops rotating at
high speed, the watch vibrates once, then all the internal data is cleared, including Bluetooth
pairing data. The match on the phone should be manually deleted at this time.
（26） low voltage detection function:
Under normal function mode, the system will detect a low voltage state every minute. When the
battery voltage is lower than 3.7V, when the voltage is less than 3.7V for 4 minutes, the system
is determined to be the system low voltage, enter the low voltage protection mode, disconnect
the Bluetooth connection, turn off the pedometer, and take the 3 step every 3 seconds with the
big lattice position, prompting the user system. In a low voltage state, when the pointer goes
to 12:00AM, stop charging the user. Under the low voltage protection mode, there is no operation
function.
：
Advertisement
