Advertisement
bar, adjust the time / minute hand with the Rabba, and then push it into Rabba.
E) check the Calorie one time at S2 and observe the location of the second seconds at 12.
（3） Bluetooth pairing:
A) click on S1 to turn on the Bluetooth, open the App of the mobile phone to match, enter
the 6 digit code on the bottom of the watch.
B) the key will be locked when paired, until 12, the fine needle points to ON position, or
the big second is spinning at high speed.
C) after the pairing is successful, the watch automatically downloads the cell phone time,
and the time / minute / second hand automatically aligns the new time.
D) the fine needle points to the ON position at 12.
（4）
chasing time before and after 1 hours：
A) to connect the Bluetooth state, turn the cell phone forward for an hour (for example,
from the current 10:00AM to 11:00AM), and see if the watch can go back for an hour if the
S1 is short.
B) to connect the Bluetooth state, turn the cell phone back for an hour (for example, from
the current 11:00AM, to the 10:00AM), naturally break the line (after the phone and watch
pull away from the line, then let the cell phone close to the watch), 12 when the fine needle
rotates and tries to connect. See if the watch is back for an hour after 30 seconds.
（5）
perpetual calendar test (to ensure sufficient battery capacity)：
A) turn off the Bluetooth of the mobile phone.
B) remove the battery and reset the battery (or pull out the pull bar in normal mode, press
the S2 for about 20 seconds, shake the watch and push it into the Laba).
C) adjust the pointer to zero according to the three needle zeroing method (the calendar
should be adjusted to the last day of February by mobile phone).
D) adjust the date of the phone to the last day of February, adjust the time to 23:00, and
then turn on the Bluetooth to match (if the battery is reset, and before the code
is matched, it doesn't need to be paired).
E) after waiting for the download time to update, the big second will rotate at high speed
to catch up time (about 40 minutes).
F) after a big second hand chasing the internal time (synchronizing with the cell phone time),
waiting for the watch time to go over 12 (cell phone 24:00), check whether the watch
is chasing the calendar at a high speed.
G) watch the calendar to turn to the March 1st if the watch's big second stop stops.
（6）
Bluetooth opening / closing (after pairing):
A) press the S1 for one second, the watch vibrate once, and when the Bluetooth is
disconnected, the fine needle points to OFF at 12.
B) click on S1 to turn on the Bluetooth. When 12, the fine needle rotates one circle
to OFF and connects to the mobile phone and then points to ON.
C) turn off the Bluetooth on your mobile phone and watch your watch on the desktop. 10
minutes later, turn on the Bluetooth phone and shake the watch to test whether the
Bluetooth can be turned on through G-Sensor.
（7）
Pedometer:
A) short press S2, big second will display Calorie, 12 fine needle will show voltage
Advertisement
