Table of Contents
Advertisement
Power Unit Placement and Connection of the Hydraulic Hoses
1. Remove the power unit from the box and locate the mounting hardware. For easy
mounting, place two bolts through the middle slots on the power unit mounting plate and
start the nuts on them. Then lift the unit up and slide the unit into position while guiding
the bolts into the slots on the bracket from the top. Install the other two bolts and tighten
securely.
2. Install longest hose first. One end has 90 degree fitting that hooks to bottom of the
offside cylinder and then route hose through the leg gusset.
DO NOT OVER TIGHTEN FITTINGS!!.
3. Route the hose up the column installing the hose clamps as you go. Then follow
across the outside of the overhead beam (installing hose clamps as you go). Down the
main side column towards your power unit.
4. Run hose through the top of your power unit bracket until the end of your hose comes
through the bottom of the bracket.
5. Install power unit elbow fitting into the port that has the red plastic cap located on the
left side of your power unit. Connect shortest hydraulic hose to the elbow fitting.
Connect the T fitting to the shortest hose and then connect overhead hose to the T
fitting.
6. Connect medium length hose with 90 degree fitting to main side cylinder and thread
through leg gussets. Run the hose up to the T fitting and tighten. See pictures –
9
Advertisement
Table of Contents
