MartinLogan Bravado User Manual page 13

c) Select Wi-fi in Settings. Ensure that Wi-Fi is
enabled on your device. Select the Wi-Fi
network with "Play-Fi " in the name.
d) Once your wireless product is selected as
the Wi-Fi network, exit iOS Settings and
open the DTS Play-Fi app. You should now
be prompted to select your wireless network
and enter your wireless network password.
e) Once your device is connected, you will notice
that the Wi-Fi Indicator light on your wireless
product will change from blinking to solid. This
may take up to a minute. If, after a minute, the
button continues to blink rapidly, setup failed
and you should try again.
PC Users:
a) The app will automatically find your device
and provide prompts for set up. If the app
does not prompt you to set up a new device,
within the app go to the settings screen and
click 'Setup Play-Fi
screen instructions.
b) Click the "Set-up" button on the screen.
c) Select the speaker(s) you want to set up.
c) Enter the password for your wireless network;
the app will connect your device to your
network. You will notice the Wi-Fi Indicator
light will have changed from blinking to
solid. This may take up to a minute. If, after a
minute, the button continues to blink rapidly,
setup failed and you should try again.
6 Your wireless product is now connected to your
wireless network. Reconnect your mobile device
or PC to your wireless network. You may re-
name your device using the app.
CONNECTING TO A WIRELESS NETWORK:
WI-FI PROTECTED SETUP (WPS)
Wi-Fi Protected Setup (WPS) is a feature found
on most wireless routers that allows your wireless
product to securely and automatically connect
13
Device'. Follow the on-
®
without needing to enter a password. WPS is not
a standard feature on all routers, and only one
wireless product can be set up at a time.
Check your router's owner's manual to see if WPS
is an available feature, or look for a button on
your router marked with the WPS logo (
router does not have WPS, then use Access Point
Wireless Setup.
1. For optimal setup conditions place your wireless
product next to your wireless router. The device
can be moved to its final location after wi-fi setup.
2. Plug in your wireless product and press the
Power button.
3. The Wi-Fi Indicator light will start rapidly blinking
for about 20 seconds while your wireless
product is booting up. If your wireless product
is not configured to connect to your network, it
will continue to blink. If this is the first time your
new wireless product is plugged in, the Wi-
Fi Indicator light will start pulsing slowly. If the
wireless product is already configured to connect
to a wi-fi network, the button will turn solid
(connected) or blink rapidly (not connected).
4. To initiate Wi-Fi Protected Setup (WPS), for 3
seconds, press and hold the Wireless Setup
button on the back of your wireless product until
you hear a tone. The Wi-Fi Indicator light will
blink twice in continuous intervals to indicate
WPS mode. Now push the WPS button (
your router. If you cannot find a WPS button on
your router, refer to the router's owner's manual.
5. Once the Wi-Fi Indicator light turns solid (not
blinking), this indicates your wireless product is
connected to your wireless network. If, after a
minute, the button continues to blink rapidly, setup
failed and you should try again.
). If your
) on