Advertisement
Device Operation
1. Connect the other end of the network cable to a PoE (Power over Ethernet) network switch, or a
PoE injector, on a network with a DHCP server. Some equipment options are listed on the
support site: www.anetdsupport.com/peripherals.
2. If properly installed, the unit should boot and show the time within 30 seconds. See Boot
Sequence below for details.
3. Consult the
Clockwise User manual
software guide for further instructions on sending audio and text to the device.
Boot Sequence
When first powered, if properly installed, the device should boot and then display the time, as
follows:
1
2
3
4
5
6
IPSWD/IPSWD-RWB
Installation Instructions
(see www.anetdsupport.com/documents) or 3
This is the 1st screen seen, and you will hear the AND
jingle during it. This screen should come on within 1-2
seconds of powering on the device.
This indicates the current firmware the device is
equipped with.
The network MAC address of the device. This is
configured at the factory.
The device is now looking for a DHCP server among
other things.
chance there is a network problem (cable, switch, ISP,
DHCP,
The IP address of the device. This is network specific,
and depends what DHCP assigns it or static if configured
as such. You should hear an audio beep during this
stage.
Once all initialization is done, the time will be displayed.
If just a colon is displayed, it is alive, but cannot find the
time. Check the NTP server settings and check that the
Internet connection is working.
For additional support, visit
If it hangs in this state, there is a good
etc.).
www.anetdsupport.com
Version 1.4
rd
party
Advertisement
