Replacing The Feed Roller - Olivetti PC-408 Service Manual

Field Service Ver. 1.0 Jul. 2009
2.1.2

Replacing the feed roller

A. Periodically replaced parts/cycle
• Feed roller: Every 300,000 feed
NOTE
• Replace the separation roller assy, feed roller and pick-up roller at the same time.
B. Procedure
1. Remove the right door.
See P.14
2. Remove the rear right cover.
See P.14
[1]
[1]
[1]
[2] [3]
Y111260-5
2. PERIODICAL MAINTENANCE PROCEDURE
[2]
[1]
A093F2C500DA
A093F2C509DA
[4]
A0XWF2C018DA
Service Manual
3. Remove two screws [1] and separa-
tion roller mounting bracket assy [2].
4. Insert a driver into the hole [1] at the
rear of the feed tray and pull out the
paper feed tray.
5. Remove three tabs [1], and remove
the harness cover [2].
6. Remove the harness from two wire
saddles [3].
7. Disconnect the connector [4].
5