Place Channels - Sears 274.4394859 Owner's Manual

Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2-13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up and down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
lo
Place channels in
memory (Autoprogram)
;ontrols Alarm Ad
3ntrols Alarm
Adjust Setup
13!
A. Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU.PROG repeatedly
to select the Setup Menu. This
menu is white.
C. Press MOVE • to highlight
Autoprogram.
D. Press MOVE • to start the TV
adding all active channels into
memory.
E. Wait until the TV has cycled
through all the channels and
returns to the original channel.
2. Add or delete channels
Controls Alarm Ad
Controls Alarm Ad
a.
Press MENU,PROG repeatedly
to select the Setup menu. This
menu is white.
B. Press MOVE • to highlight
Channel Memory.
C. Press MOVE • to underline the
channel number.
D.
E.
F°
Select the channel number you
want to add or delete with the
number buttons.
Press MOVE • to add or delete
a channel (you will see Stored
on the screen when added and
Erased when deleted).
Repeat D and E for more
channels.
2O