Advertisement
PROBLEM
!, Neither vacuum
motor nor pump
motor
runs.
2, Vacuum
motor
runs, but
there
Is no
spray at the nozzle.
3, Spray from
the
floor
nozzle does
not
come out evenly,
i
4, Motor runs but cleaner
does not pick up
solution
from carpet
(no exhaust
from
top of cleaner),
5. Spray connections
leak.
POSSIBLE SOLUTIONS *
1, Be sure power
switch is in "ON" position,
2. Be sure power
cord ts plugged
In securely,
3. Check
wall electrical
outlet
(by plugging
in a known
working
electrical appliance),
1, Be sure Short Cord from Power Head to Solution Tank is
securely
plugged
Into receptacle
on the Power Head,
2, Check
that Solution Tank Is full,
3, Be sure Pump Switch is in the "HI" or _LO" position,
4, Nozzle Ports may be clogged,
See Illustration
below
to
unclog,
!, Unclog the Nozzle Port, See Illustration below,
1, Recovery
Tank is full of dirty water and must be emptied.
2, Check for clogged
hose or nozzle, Clogs could resuit from
picking up material
such as carpet
strings, shoe laces, etc.
I, Disassemble
nut at leaking
connection,
Be sure washer is
properly
seated,
Reassemble
and tighten
securely,
"If the "Possible Solutions" to "Problems"
iisted In the chart do not correct
the problem,
take your cleaner to a Sears
Service Center for professional
service, Repairs not listed In this chart require prafessional and specific knowledge
of this model cleaner and could result in safely hazards and personal Injury If not made by o qualified Sears Service
Technlclan.
TO UNCLOG NOZZLE PORT
See Fisu re 18
1. Insert the point of a needle or pin into Spray Port to
unclog,
NOTE: Do not let the point of needle or pin touch any
part of the Spray Pad surface or Spray Pad will not
spray solution properly,
SPRAY PORT
CAUTION: Do not let needle
or pin touch this surface,
NEEDLE OR
PIN
Advertisement
