Download Print this page

Advertisement

Quick Links

MAINTENANCE SCHEDULE
Maintenance frequency may vary depending on the number of hours
the shock is ridden and the condition under which it is ridden. Heat,
frame design, dust, mud, and adjustment settings are all factors that
need to be taken into consideration in determining the frequency of
basic maintenance and oil changes.
AFTER EACH
USE
Clean under
the bottom-out
Yes
bumper
Clean shock
Yes
exterior
Check shaft
for damage or
Inspect
rust
Check seal
head for leaks
Inspect
or loosening
Check nuts for
Inspect
loosening
Check DU
Inspect
bushings
Check spring
Inspect
Change oil,
piston and
wearband,
clean interior
parts, check
nitrogen
IMPORTANT NOTE:
NOTE: MRP RECOMMENDS SENDING YOUR SHOCK EXCLUSIVELY TO MRP OR
A RECOMMENDED SERVICE CENTER FOR ALL YOUR OIL CHANGE AND SEAL
REPLACEMENT MAINTENANCE.
MORE TUNING INFORMATION AT
END OF EACH
ANNUALLY
SEASON
Yes
Yes
Yes
Yes
Inspect
Inspect
Inspect/Replace
Replace
Inspect
Inspect
Inspect
Inspect
Inspect
Inspect
Recommended
OWNER'S
MANUAL

Advertisement

loading
Need help?

Need help?

Do you have a question about the hazzard and is the answer not in the manual?

Questions and answers

Summary of Contents for MRP hazzard

  • Page 1 Recommended parts, check nitrogen IMPORTANT NOTE: NOTE: MRP RECOMMENDS SENDING YOUR SHOCK EXCLUSIVELY TO MRP OR A RECOMMENDED SERVICE CENTER FOR ALL YOUR OIL CHANGE AND SEAL OWNER’S REPLACEMENT MAINTENANCE. MORE TUNING INFORMATION AT MANUAL...
  • Page 2 On receipt of the product by MRP, if it is found to be defective, MRP will determine replacement or repair of the product at its sole discretion. MRP shall not be liable for any indirect, special or consequential damages. Warranty...
  • Page 3 (screw in). There are your shock and bike. If you contact MRP or your local MRP dealer, we appoximately 14 clicks (two complete can verify if you can use the original mounting hardware that came rotations) of high-speed compression with your bike.
  • Page 4 If you cannot achieve appropriate rebound speeds, a change careful not to apply too much preload. This can cause “coil binding”, to the internal shimstack may be needed. Contact MRP if this is the which is when the coils of the spring rub against each other under case.