Operation; Before Using Your Battery Charger; Assemblingyourcharger; Plugging It In - DieHard 200.713101 Owner's Manual

It is importantto understandyour charger's requirements.This section will tell you
about your charger's electrical requirementsand how to prepare a battery for
charging.
ASSEMBLINGYOURCHARGER
Included with your battery charger are two
cord wrap posts for storage of the clamp
cables.
To install, align the three tabs to corre-
spond with the three receptacles and
push until you hear a snap.
Wrap clamp cord after unplugging the
power cord and store your charger in a
dry location.
[_ (--Cord Wrap Cleat
PLUGGING IT IN
WARNING: Electrical Shock Hazard.
Be sure that the power cord fits properly
into the outlet. If not, have a qualified
technician install a proper outlet. Never
alter the AC cord or plug provided.
Improper connection can result in
electrical shock.
Your charger requires a 120V receptacle
installed according to all local codes and
ordinances.
USING AN EXTENSION CORD
The use of an extension cord is not
recommended. If you must use an
extension cord, please make sure
that you follow these guidelines:
• Make sure that the pins on charger's
power cord fit firmly into the extension
cord, and that the extension cord fits
firmly into the receptacle.
• Check that the extension cord is
properly wired and in good electrical
condition.
Make sure that the wire size is large
enough for its length and for the AC
ampere rating as specified in the chart
below.
i_iii!iiiiiii!!iiiiiiiiiiiii iifi i i ¸ i il _ iiiiiii :_ i¸ i iii_
Length of Cord, in Feet 25 50 100 150
AWG* Size of Cord 18 16 12 10
"AWG=AmericanWireGauge
5