Sealife Reefmaster DC100 Instruction Manual page 54

Sealife instruction manual digital camera dc100, dc200
Hide thumbs Also See for Reefmaster DC100:
Table of Contents

Advertisement

PIONEERmanREV
11/19/01
6:00 PM
How to set-up the Underwater Housing
Set up camera
1. Insert 4 fully charged Ni-MH batteries (size AA, capacity at least 1600 mAh). See page 53 for more battery
information. Make sure you insert the batteries with the correct + and – polarity.
2. Clean camera lens with dry, clean cotton cloth.
3. Make sure camera focus knob (lens) is set to standard distance. DO NOT SET TO MACRO.
4. Remove camera strap since this may prevent the camera from correctly seating itself inside the housing.
5. Set camera to Sea mode. If you are using an External Flash, set camera to External Flash mode. See page 25
for detailed instructions on how to set camera to Land, Sea or External Flash modes.
Set up housing
Opening and loading of the housing should be done only in dry cool air, such as in an air-conditioned room to
prevent fogging.
1. Open the housing by pulling up latch on side of housing. Do not extend housing lid beyond its stop point or
damage may occur to the hinge area.
2. Carefully inspect O-rings for damage and make sure O-ring is firmly seated in its
3. Clean the housing glass lens port using clean, dry cotton cloth. It is recommended
4. Carefully insert camera into housing. Make sure camera is clean and dry.
5. Insert two Anti-Fog desiccant capsules into special slots inside housing. Note: New
6. Carefully clean O-rings and inside of housing area where O-ring makes contact. Use
Page 45
groove. If O-ring is damaged and requires replacement, contact SeaLife Service
Center (For service details, see page iii).
to apply anti-fog solution to the inside surface of the housing lens.
desiccant capsules will be blue in color. As the desiccant absorbs moist air, it turns
from blue to light pink. Replace desiccant capsules when color changes to light pick.
cleaning brush provided in Care Kit. O-ring must not be wet when sealing housing,
allow these areas to dry.
O-Ring must be absolutely clean of all lint, sand or other small particles.
Do not grease O-rings.
45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Reefmaster dc200

Table of Contents